When.com Web Search

  1. Ads

    related to: dc 5v charger cable

Search results

  1. Results From The WOW.Com Content Network
  2. DC connector - Wikipedia

    en.wikipedia.org/wiki/DC_connector

    Although the nominal voltage of a 12 V lead acid battery is 12 V DC, when the engine is running the car's battery charging system will bring the system voltage to 13.8 V DC or higher. [10] The possible range of battery voltages from 11–15 V DC must be taken into account by devices attached to the cigar lighter socket.

  3. Coaxial power connector - Wikipedia

    en.wikipedia.org/wiki/Coaxial_power_connector

    Nokia 2-mm DC Charging Interface Specification [3] 4.65–9.3 V Nokia DC-096 (0.48×2.1 mm on socket side) Nokia AC-3 charger Nokia 2-mm DC Charging Interface, used in Nokia phones and Bluetooth headphones 2.35 0.70 9.5 A EIAJ-01 0–3.15 V Kobiconn 3218-EX Lumberg 1636 01 Kobiconn 0307-EX (inline)

  4. AC adapter - Wikipedia

    en.wikipedia.org/wiki/AC_adapter

    An AC adapter or AC/DC adapter (also called a wall charger, power adapter, power brick, or wall wart) [1] is a type of external power supply, often enclosed in a case similar to an AC plug. [2] AC adapters deliver electric power to devices that lack internal components to draw voltage and power from mains power themselves.

  5. EIAJ connector - Wikipedia

    en.wikipedia.org/wiki/EIAJ_connector

    This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input). Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter. Previously known as EIAJ RCX-5321.

  6. SAE J3068 - Wikipedia

    en.wikipedia.org/wiki/SAE_J3068

    J3068 defines a system of conductive power transfer to an electric vehicle using a coupler capable of transferring single-phase and three-phase AC power as well as DC power, and defines a digital communication system for control. J3068 also specifies requirements for the vehicle inlet, supply equipment connector, mating housings and contacts.

  7. Battery charger - Wikipedia

    en.wikipedia.org/wiki/Battery_charger

    Chargers for stationary battery plants may have adequate voltage regulation and filtration and sufficient current capacity to allow the battery to be disconnected for maintenance, while the charger supplies the direct current (DC) system load. The capacity of the charger is specified to maintain the system load and recharge a completely ...