Ads
related to: used 350 small block engine dolly stand cradle storage- Hydraulic Floor Crane
Six steel swivel casters.
Folds for convenient storage.
- Aluminum Gantry Cranes
Lightweight, corrosion-resistant
aluminum that holds up to a ton.
- Electric Chain Hoists
NEMA 4 Rated. 115V. CSA Approved.
Overload protection for operation.
- Hand Chain Hoists
Steel body w/ hardened load chain.
Forged steel swivel hooks w/ hooks.
- Hydraulic Floor Crane
Search results
Results From The WOW.Com Content Network
The LS9 and LT9 engines were replaced for 1987 by the L05 TBI (throttle-body fuel injection) engines. Most of the small-block engines in this timeframe were built at either the Flint engine plant in south Flint, Michigan, or at St. Catharines, Ontario. The Flint plant was producing about 5,200 engines per day in the mid-1980s, and had a slower ...
The LT-1 is a Chevrolet small-block engine produced by the Chevrolet division of General Motors between 1970 and 1972. It was available exclusively in the Corvette and Camaro and was produced in relatively small quantities. It is regarded today as one of the greatest of the Chevrolet small-blocks, an engine that has been in production since 1955.
Engine stand (red) holding a partially disassembled combustion engine. An engine stand is a tool commonly used to repair large heavy gasoline or diesel engines. It uses a heavy cantilevered support structure to hold the engine in midair so that the mechanic has access to any exposed surface of the engine. They are often referred to as cherry ...
Chevrolet small-block engine: 1968-1972 200 hp @ 4400 RPM 300 lb-ft @ 2400 RPM 327 cu in (5.4 L) V8 Chevrolet small-block engine: 1967-1968 220 hp @ 4400 RPM 320 lb-ft @ 2800 RPM 350 cu in (5.7 L) V8 Chevrolet small-block engine: 1969-1972 4-bbl 250 hp @ 4600 RPM 350 lb-ft @ 3000 RPM RPO code LS9 351 cu in (5.8 L) V6 GMC V6 engine
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
An engine crane (also referred as engine hoist [1]) is a common repair tool used in vehicle repair shops to remove or install gasoline or diesel engines in small and crowded vehicle engine compartments. It uses a heavy cantilevered support structure to hold the engine in mid-air so that the mechanic can carefully connect or disconnect fragile ...