Ads
related to: hole punch for spiral binding machine near me for sale by owner
Search results
Results From The WOW.Com Content Network
[citation needed] First, a punch creates holes along the edge of the document. Second, a coil inserter spins the coils through the holes. Third, a pair of coil crimping pliers or a crimping machine is used to cut off the excess coil and crimp the end to prevent the coil from coming loose from the document.
To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.
Coil binding uses a spring-like coil, threaded into the punched holes. Comb binding uses a plastic strip with "fingers" that clip into the punched holes. Both use their own types of specialized hole punches. Comb binding typically punches 19 or 23 rectangular holes (for letter and A4 paper sizes, respectively).
In the past, some comb binding machines would come with a wire closer. These machines were designed to be used with 19-loop wire, which uses the same pattern as for plastic comb binding . This hole pattern will have 19 longer rectangular holes that are on 14 mm ( 9 ⁄ 16 in) centers, for a total length of 280 mm (11 in).
This type of binding uses either a 3:1 pitch hole pattern with three holes per inch or a 2:1 pitch hole pattern with two holes per inch. The three to one hole pattern is used for smaller books that are up to 9/16" in diameter while the 2:1 pattern is normally used for thicker books as the holes are slightly bigger to accommodate slightly ...
A manual knockout punch can handle holes from 0.5 to 1.25 in (13 to 32 mm). The ratchet system has a custom ratcheting wrench that uses a ball screw to make the process faster and easier. This type of system has a mechanical advantage of approximately 220:1 and can punch holes up to 3 in (76 mm) in diameter in 10 gauge mild steel . [ 3 ]