Ad
related to: dhcp server cisco switch
Search results
Results From The WOW.Com Content Network
The DHCP server permanently assigns an IP address to a requesting client from a range defined by an administrator. This is like dynamic allocation, but the DHCP server keeps a table of past IP address assignments, so that it can preferentially assign to a client the same IP address that the client previously had. Manual allocation
Network Admission Control (NAC) refers to Cisco's version of network access control, which restricts access to the network based on identity or security posture.When a network device (switch, router, wireless access point, DHCP server, etc.) is configured for NAC, it can force user or machine authentication prior to granting access to the network.
If a DHCP client outside the DHCP server's subnet broadcasts an address request, it is the helper that forwards the message to the DHCP server. The server then chooses an address and sends the client a unicast message, using the helper to send the message back to the client's subnet. The address is reserved for a limited time while the DHCP ...
CNR is a DHCP/DHCPv6 server used by cable-based and similar network service providers because of its support for fail-over between redundant servers, Dynamic DNS updates so that DHCP leases are reflected in DNS data, integration with directory services using LDAP Version 3, and ability to handle high request rates. It is also extensible.
The network to which the supplicant needs to interact with must have a RADIUS Server (also known as an Authentication Server or an Authenticator), a Dynamic Host Configuration Protocol (DHCP) server if automatic IP address assignment is needed, and in certain configurations, an Active Directory domain controller.
DHCP servers allocate IP addresses to clients on a LAN. DHCP snooping can be configured on LAN switches to exclude rogue DHCP servers and remove malicious or malformed DHCP traffic. In addition, information on hosts which have successfully completed a DHCP transaction is accrued in a database of bindings which may then be used by other security ...
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
In a correct architecture and configuration, the Clean Access Server would hand out IP subnets and addresses via DHCP on its untrusted interface using a 30-bit network address and 2 bits for hosts, therefore only one host could be placed in each DHCP scope/subnet at any given time. This segregates unauthorized users from each other and from the ...