Search results
Results From The WOW.Com Content Network
In 1936, it took several days to recharge a car battery. Hunter sought to find a better, faster way to recharge batteries. With the help of a former Washington University in St. Louis electrical engineering professor, Hunter began developing a new design. His quick charge battery recharger was based on a diverter pole generator.
A battery charger, recharger, or simply charger, [1] [2] is a device that stores energy in an electric battery by running current through it. The charging protocol—how much voltage and current, for how long and what to do when charging is complete—depends on the size and type of the battery being charged.
Lithium ion charger voltage/current profile obtained using a battery simulator. Once the simulated battery voltage is set, the user connects the charger to be tested to the input of the simulator. The charger will detect that a battery has been connected and the charging process will begin.
It may also prevent completely draining ("deep discharging") a battery, or perform controlled discharges, depending on the battery technology, to protect battery life. [ 3 ] [ 4 ] The terms "charge controller" or "charge regulator" may refer to either a stand-alone device, or to control circuitry integrated within a battery pack, battery ...
Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.
The Megawatt Charging System (MCS) is a charging connector under development for large battery electric vehicles. The connector will be rated for charging at a maximum rate of 3.75 megawatts (3,000 amps at 1,250 volts direct current (DC)).
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]
CCS1 (Combined Charging System Combo 1) plug as used in North America. It is an extension of the J1772 standard AC charging connector. CCS Combo 1 vehicle inlet showing the J1772 and the two DC fast-charging pins Connectors: Incomplete Combo 2 (left) showing the two large direct current (DC) pins below, while the four alternating current (AC) pins for neutral and three-phase are removed, while ...