Ads
related to: ls truck intake manifold rear vacuum plug assembly diagram
Search results
Results From The WOW.Com Content Network
The 4.8L and the 5.3L are smaller truck versions of the LS1 and were designed to replace the 305 and the 350 in trucks. The 4.8L and 5.3L engines share the same Gen III LS-series engine block and heads (upper end) and therefore, most parts interchange freely between these engines and other variants in the LS family.
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...
It offers the airflow of more expensive heads, at a much lower cost. It does, however, require a specific intake manifold (the L31 has four bolts per head attaching the intake manifold, as opposed to the "traditional" six bolts per head found on older Chevrolet small-blocks). Chevrolet's L31 was replaced by GM's LS-based 5.3L LM7 and 6.0L LQ4.
Manifold vacuum, or engine vacuum in a petrol engine is the difference in air pressure between the engine's intake manifold and Earth's atmosphere. Manifold vacuum is an effect of a piston 's movement on the induction stroke and the airflow through a throttle in the intervening carburetor or throttle body leading to the intake manifold.
A redesigned cylinder head and manifold for improved air flow. Variable exhaust valve timing (the LW2 engine only had variable intake valve timing) Specially-developed fuel injectors. New pistons with pentroof-style centre-domes and valve eyelets for a higher compression ratio of 12.2:1 (compared to 10.2:1 for the dual fuel engine).
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.