Search results
Results From The WOW.Com Content Network
The Beale number can be defined in terms of a Stirling engine's operating parameters: = where: B n is the Beale number; Wo is the power output of the engine ; P is the mean average gas pressure or (MPa, if volume is in cm 3) V is swept volume of the power piston (m 3, or cm 3, if pressure is in MPa)
A Stirling engine uses a single-phase working fluid that maintains an internal pressure close to the design pressure, and thus for a properly designed system the risk of explosion is low. In comparison, a steam engine uses a two-phase gas/liquid working fluid, so a faulty overpressure relief valve can cause an explosion.
The Stirling cycle is a thermodynamic cycle that describes the general class of Stirling devices. This includes the original Stirling engine that was invented, developed and patented in 1816 by Robert Stirling with help from his brother, an engineer.
A Fluidyne engine is an alpha or gamma type Stirling engine with one or more liquid pistons. It contains a working gas (often air), and either two liquid pistons or one liquid piston and a displacer. [1] The engine was invented in 1969. [2] The engine was patented in 1973 by the United Kingdom Atomic Energy Authority. [3] [2]
The working fluid of a heat engine or heat pump is a gas or liquid, usually called a refrigerant, coolant, or working gas, that primarily converts thermal energy (temperature change) into mechanical energy (or vice versa) by phase change and/or heat of compression and expansion.
In closed cycle, the lower pressure can be significantly above ambient pressure, and He or H 2 working gas can be used. Because of the higher pressure difference between the upward and downward movement of the work-piston, specific output can be greater than of a valveless Stirling engine. The added cost is the valve. Ericsson's engine also ...
The pseudo Stirling cycle, also known as the adiabatic Stirling cycle, is a thermodynamic cycle with an adiabatic working volume and isothermal heater and cooler, in contrast to the ideal Stirling cycle with an isothermal working space. [1] The working fluid has no bearing on the maximum thermal efficiencies of the pseudo Stirling cycle. [2]
In the process of passing through a cycle, the working fluid (system) may convert heat from a warm source into useful work, and dispose of the remaining heat to a cold sink, thereby acting as a heat engine. Conversely, the cycle may be reversed and use work to move heat from a cold source and transfer it to a warm sink thereby acting as a heat ...