Ads
related to: convert 35mm to inches fraction formamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
When using "hand in" to convert to hands and inches, the rounded hands and inches values are equivalent, and use the same fraction, if any. Special rounding of the inches value only occurs when "hand in" is the output.
35 mm equivalent focal lengths are calculated by multiplying the actual focal length of the lens by the crop factor of the sensor. Typical crop factors are 1.26× – 1.29× for Canon (1.35× for Sigma "H") APS-H format, 1.5× for Nikon APS-C ("DX") format (also used by Sony, Pentax, Fuji, Samsung and others), 1.6× for Canon APS-C format, 2× for Micro Four Thirds format, 2.7× for 1-inch ...
The result is expressed in inches and is usually (but not always) rounded to a convenient fraction. For instance, a 6.4x4.8 mm sensor has a diagonal of 8.0 mm and therefore an optical format of 8.0*3/2 = 12 mm, which is expressed as 1 ⁄ 2 inch in imperial units. The reason it is expressed in inches is historical, dating back to the early days ...
In the following quote, an "apertal ratio" of "1 ⁄ 24" is calculated as the ratio of 6 inches (150 mm) to 1 ⁄ 4 inch (6.4 mm), corresponding to an f /24 f-stop: In every lens there is, corresponding to a given apertal ratio (that is, the ratio of the diameter of the stop to the focal length), a certain distance of a near object from it ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...