When.com Web Search

  1. Ads

    related to: isolation transformer for audio equipment near me

Search results

  1. Results From The WOW.Com Content Network
  2. Isolation transformer - Wikipedia

    en.wikipedia.org/wiki/Isolation_transformer

    In electronics testing and servicing, an isolation transformer is a 1:1 (under load) power transformer used for safety. Without it, exposed live metal in a device under test is at a hazardous voltage relative to grounded objects such as a heating radiator or oscilloscope ground lead (a particular hazard with some old vacuum-tube equipment with ...

  3. Ground loop (electricity) - Wikipedia

    en.wikipedia.org/wiki/Ground_loop_(electricity)

    With the increasing trend towards digital processing and transmission of audio signals, the full range of isolation by small pulse transformers, optocouplers or fiber optics become more useful. Standard protocols such as S/PDIF , AES3 or TOSLINK are available in relatively inexpensive equipment and allow full isolation, so ground loops need not ...

  4. Line isolation transformer - Wikipedia

    en.wikipedia.org/wiki/Line_isolation_transformer

    A line isolation transformer for telephone use is a special type of impedance matching transformer that is used to couple telephone land lines to subscriber equipment to prevent dangerous common mode voltages from appearing on the line. It has a specific 600Ω input impedance which matches the telephone equipment. [1]

  5. AC/DC receiver design - Wikipedia

    en.wikipedia.org/wiki/AC/DC_receiver_design

    In areas using 110–120 volt AC, a simple half-wave rectifier limited the maximum plate voltage that could be developed; this was adequate for relatively low-power audio equipment, but television receivers or higher-powered amplifiers required either a more complex voltage doubler rectifier or warranted the use of a power transformer with a ...

  6. Ground lift - Wikipedia

    en.wikipedia.org/wiki/Ground_lift

    Specially wired signal adaptors may leave the shield connection disconnected, or connected to safety ground through an RF bypass capacitor. Isolation transformers may be used to convert from balanced lines to single-ended inputs, and also to isolate the cable shield from the equipment safety ground.

  7. Galvanic isolation - Wikipedia

    en.wikipedia.org/wiki/Galvanic_isolation

    A transformer is the most widespread example of galvanic isolation. An opto-isolator is a very popular method of isolation in digital circuits. Cross-section of dual in-line package opto-isolators. Relative sizes of LED (red) and sensor (green) are exaggerated.