Search results
Results From The WOW.Com Content Network
A solid-state contactor is a heavy-duty solid state relay, including the necessary heat sink, used where frequent on-off cycles are required, such as with electric heaters, small electric motors, and lighting loads. There are no moving parts to wear out and there is no contact bounce due to vibration.
Consider a relay that has to energize to show a green light. If a wire breaks, or the battery is drained, then the relay will de-energize and the signal will show a red light, which is fail-safe. If a stray wire from another circuit touches the wire connected to that same relay, then that would be a wrong side failure, which is potentially ...
A magnetic starter has a contactor and an overload relay, which will open the control voltage to the starter coil if it detects an overload on a motor. [1] [2] The overload relay opens a set of contacts that are wired in series with the supply to the contactor feeding the motor. The characteristics of the heaters can be matched to the motor so ...
A starter solenoid is an electromagnet which is actuated to engage the starter motor of an internal combustion engine. It is normally attached directly to the starter motor which it controls. Its primary function is as the actuating coil of a contactor (a relay designed for large electric currents) which connects the battery to the starter ...
From left to right: a field with a source, a field with a sink, a field without either. In the physical sciences, engineering and mathematics, sources and sinks is an analogy used to describe properties of vector fields. It generalizes the idea of fluid sources and sinks (like the faucet and drain of a bathtub) across different scientific ...
For premium support please call: 800-290-4726 more ways to reach us
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The redundant design ensures that wiring errors do not lead to the loss of the safety function. Two relays (K1, K2) with positive-guided contacts provide the safe switching contacts. The two input circuits CH1 and CH2 each activate one of the two internal relays. The circuit is activated via the start relay K3.