Ads
related to: atx power supply on pins diagram chart
Search results
Results From The WOW.Com Content Network
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
12V only power connector (labelled P1, though it is not compatible with the ATX 20 or 24 pin connector): This is a 10 or 16-pin Molex connector supplying the motherboard with three or six 12 V lines with common returns, a 'supply OK' signal, a 'PSU ON' signal and a 12 or 11 V auxiliary supply. One pin is left unused.
Swap shapes in all +12V2 connector pins, change all text color to black, fix text inside pins (change font size to 9 in 24pin connector, change font size to 10 in 4pin connector, change alignment of text to left justify, center all text again). 09:23, 5 February 2015: 378 × 750 (54 KB) Sbmeirow
The most notable difference from modern 20/24-pin ATX power connectors is that the AT power supply connector did not have a signal to turn on the power supply, and also did not supply separate, "always-on" +5V standby power. The power supply was instead turned on and off via a mechanical switch that disconnected mains power. Modern, ATX ...
PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM). Conversely the power supply is turned off when the PS ...
ATX12VO power supply connector Color Signal Pin Pin Signal Color Green PS_ON# 1 6 PWR_OK: Gray Black COM 2 7 +12 VSB Purple Black COM 3 8 +12 V1 DC Yellow Black COM 4 9 +12 V1 DC Yellow TBD Reserved 5 10 +12 V1 DC Voltage Sensing Pin Yellow
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
The power connector on the 3½-inch floppy drive, informally known as "the Berg connector", is 2.50 mm pitch (distance from center to center of pins). The power cable from the ATX power supply consists of 20 AWG wire to a 4-pin female connector. [ 1 ]