Search results
Results From The WOW.Com Content Network
Diagram of turning vehicle. On wheeled vehicles with the common type of front wheel steering (i.e. one, two or even four wheels at the front capable of steering), the vehicle's turning diameter measures the minimum space needed to turn the vehicle around while the steering is set to its maximum displacement from the central 'straight ahead' position - i.e. either extreme left or right.
Intersecting the axes of the front wheels on this line as well requires that the inside front wheel be turned, when steering, through a greater angle than the outside wheel. [2] Rather than the preceding "turntable" steering, where both front wheels turned around a common pivot, each wheel gained its own pivot, close to its own hub.
This can be contrasted with steer, which is the antisymmetric angle, i.e. both wheels point to the left or right, in parallel (roughly). Negative toe, or toe out, is the front of the wheel pointing away from the centreline of the vehicle. Positive toe, or toe in, is the front of the wheel pointing towards the centreline of the vehicle. [2]
A steering ratio of x:y means that a turn of the steering wheel x degree(s) causes the wheel(s) to turn y degree(s). In most passenger cars , the ratio is between 12:1 and 20:1. For example, if one and a half turns of the steering wheel, 540 degrees, causes the inner & outer wheel to turn 35 and 30 degrees respectively, due to Ackermann ...
Camber is the angle which the vertical axis of the wheel makes with the vertical axis of the vehicle. This angle is very important for the cornering performance of the vehicles. Generally, a Camber around 0.5-2 degrees is given on the vehicles. Depending upon wheel orientation, Camber can be of three types. 1. Positive Camber
The term scrub radius derives from the fact that either in the positive or negative mode, the tire does not turn on its centerline (it scrubs the road in a turn) and due to the increased friction, more effort is needed to turn the wheel. Large positive values of scrub radius, 4 inches/100 mm or so, were used in cars for many years.
If the castored wheel is attached to the front of a narrow tilting vehicle the castor will automatically place itself on the correct steer angle for the tilt and the speed of the vehicle. A system can be used below 10 mph (16 km/h) to improve slow-speed performance where the steerable wheel(s) are progressively captured to the vehicle tilt ...
The steering axis angle is called caster angle when measured from vertical axis or head angle when measured from horizontal axis. The steering axis is the axis about which the steering mechanism (fork, handlebars, front wheel, etc.) pivots. The steering axis angle usually matches the angle of the head tube.