Search results
Results From The WOW.Com Content Network
Each power line also includes circuit breakers. The combination of power lines provides excess capacity. Circuit breakers disconnect a power line when monitors detect an overload. Power is redistributed across the remaining lines. [citation needed] At the Toronto Airport, there are 4 redundant electrical lines. Each of the 4 lines supply enough ...
This is a critical point – each power supply must be able to power the entire server by itself. Redundancy is further enhanced by plugging each power supply into a different circuit (i.e. to a different circuit breaker). Redundant protection can be extended further yet by connecting each power supply to its own UPS.
Other common implementations include aerospace, where redundant systems are used to improve safety and integrity of spacecraft, electric power systems and automobiles, where the emergency brake is available in a car as a redundant component in case of failure of the main brake systems. The German power system, which has N+1 redundancy and is ...
Redundant power supply contains two (or more) modules. For a given power supply, efficiency varies depending on how much power is being delivered. Supplies are typically most efficient at between half and three-quarters load, much less efficient at low load, and somewhat less efficient at maximum load.
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
Tier III: full N+1 redundancy of all systems, including power supply and cooling distribution paths; Tier IV: as Tier III, but with 2N+1 redundancy of all systems; A Tier III system is intended to operate at Tier II resiliency even when under maintenance, and a Tier IV system is intended to operate at Tier III resiliency even when under ...
In a common variant found in tower cases, the line-voltage switch was connected to the power supply with a short cable, allowing it to be mounted apart from the power supply. An early microcomputer power supply was either fully on or off, controlled by the mechanical line-voltage switch, and energy saving low-power idle modes were not a design ...
A regulated power supply is an embedded circuit; it converts unregulated AC (alternating current) into a constant DC. With the help of a rectifier it converts AC supply into DC. Its function is to supply a stable voltage (or less often current), to a circuit or device that must be operated within certain power supply limits.