Search results
Results From The WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.
The French scale, also known as the French gauge or Charrière system, is a widely used measurement system for the size of catheters.It is commonly abbreviated as Fr but may also be abbreviated as Fg, FR or F, and less frequently as CH or Ch (referencing its inventor, Charrière).
Its 4.5 mm (0.18 in) caliber boat-tail spitzer bullet was 22 mm (0.87 in) long and made by cold rolling solid copper wire. [1] The lightweight bullet of 1.58 g (24.4 gr) reportedly achieved a muzzle velocity of about 1,000 m/s (3,300 ft/s) and a muzzle energy of 790 J (580 ft⋅lbf).
English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.
It is also used in field target competitions, where it competes with .20 caliber (5 mm) and .22 caliber (5.6 mm) rifles. Steel BBs are typically slightly smaller than lead BBs at 0.175-inch (4.4 mm) diameter, although the bore diameter of the barrel are the same. Some air guns are designed to accept .177 pellets, .177 lead shot, or .175 steel ...
For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings. When the mesh is shaken, small broken pieces and dust pass through the mesh while whole peanuts are retained on the mesh. A commercial peanut buyer might use a test like this to determine if a batch of peanuts has too many broken pieces.
Feet and inches can be converted, optionally with fractions. {{convert|12.34|m|ft}} ... → 2 + 1 / 2 inches (63.5 mm) An output can be expressed with a fraction ...