Search results
Results From The WOW.Com Content Network
A capacitance multiplier is designed to make a capacitor function like a much larger capacitor. This can be achieved in at least two ways. An active circuit, using a device such as a transistor or operational amplifier; A passive circuit, using autotransformers. These are typically used for calibration standards.
Analyzing the circuit of the lamp shown in the image, at 50 Hz, the 1.2 μF capacitor has a reactance of 2.653 kΩ. By Ohm's law, the current is limited to 240 V/2653 Ω ≈ 90 mA, assuming that voltage and frequency remain constant. The LEDs are connected in parallel with the 10 μF electrolytic filter capacitor.
Mixed-mode simulation is handled on three levels: with primitive digital elements that use timing models and the built-in 12 or 16 state digital logic simulator, with subcircuit models that use the actual transistor topology of the integrated circuit, and finally, with inline Boolean logic expressions.
Figure 2.Greinacher circuit. The Greinacher voltage doubler is a significant improvement over the Villard circuit for a small cost in additional components. The ripple is much reduced, nominally zero under open-circuit load conditions, but when current is being drawn depends on the resistance of the load and the value of the capacitors used.
The following table is split into two groups based on whether it has a graphical visual interface or not. The latter requires a separate program to provide that feature, such as Qucs-S, [1] Oregano, [2] or a schematic design application that supports external simulators, such as KiCad or gEDA.
For example, an inductor often acts as though it includes a parallel capacitor, because of its closely spaced windings. When a potential difference exists across the coil, wires lying adjacent to each other are at different potentials. They act like the plates of a capacitor, and store charge.
The simplest switched-capacitor (SC) circuit is made of one capacitor and two switches S 1 and S 2 which alternatively connect the capacitor to either in or out at a switching frequency of . Recall that Ohm's law can express the relationship between voltage, current, and resistance as:
A capacitor can store electric energy when it is connected to its charging circuit and when it is disconnected from its charging circuit, it can dissipate that stored energy, so it can be used as a temporary battery. Capacitors are commonly used in electronic devices to maintain power supply while batteries are being changed.