Ads
related to: decorative laser cut metal panelsxometry.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
For sheet metal cutting, the focal length is usually 1.5–3 inches (38–76 mm). [7] [8] Advantages of laser cutting over mechanical cutting include easier work holding and reduced contamination of workpiece (since there is no cutting edge which can become contaminated by the material or contaminate the material). Precision may be better since ...
Oxygen, nitrogen or air is fed through the same nozzle from which the laser beam exits. The metal is heated and burnt by the laser beam, cutting the metal sheet. [20] The quality of the edge can be mirror smooth and a precision of around 0.1 mm (0.0039 in) can be obtained. Cutting speeds on thin 1.2 mm (0.047 in) sheet can be as high as 25 m ...
The same conduction that works against the spot vaporisation of metal is an asset if the objective is to vaporise some other coating away from the metal. Laser engraving metal plates are manufactured with a finely polished metal, coated with an enamel paint made to be "burned off". At levels of 10 to 30 watts, excellent engravings are made as ...
Helium–silver (HeAg) metal-vapor laser [3] 224.3 nm Scientific research Strontium vapor laser: 430.5 nm Scientific research Neon–copper (NeCu) metal-vapor laser [3] 248.6 nm Electrical discharge in metal vapor mixed with neon buffer gas. Scientific research: Raman and fluorescence spectroscopy [4] [5] Copper vapor laser: 510.6 nm, 578.2 nm
The lids were often adorned with a portrait, a classical vignette, portrait miniature, hardstone inlays, or micromosaic panel. Some of the most expensive just used subtly different colours of gold. Perhaps the most widely used semi-precious metal was silver and snuffs of all shapes and sizes were made in that metal during snuff's great popularity.
One takes great care to remove any surface defects in the metal, like pits, that could allow bacteria to grow. A #4 dairy or sanitary finish is produced by polishing with a 180–240 grit belt or wheel finish softened with 120–240 grit greaseless compound or a fine non woven abrasive belt or pad.
Ad
related to: decorative laser cut metal panels