Search results
Results From The WOW.Com Content Network
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The Chrysler 300 continues a tradition of full-sized, front-engine, rear-wheel drive, V8-powered luxury sedans the company has offered, starting in the 1940s with the Chrysler Saratoga and Chrysler New Yorker, followed by the Chrysler Windsor, Chrysler Newport, and the Chrysler Cordoba, with the last rear wheel drive sedan, the Chrysler Fifth Avenue that ended production in 1989.
The Pentastar engine was introduced at the 2009 New York Auto Show. [2] [3] The engine design allows the use of E85 or 87 octane fuel and features dual variable valve timing. Forced induction, and cylinder deactivation options were engineered into the engine design, but have not been implemented from the factory, remaining "on the shelf" as of ...
The CAN bus protocol has been used on the Shimano DI2 electronic gear shift system for road bicycles since 2009, and is also used by the Ansmann and BionX systems in their direct drive motor. The CAN bus is also used as a fieldbus in general automation environments, primarily due to the low cost of some CAN controllers and processors.
A modern vehicle can have more than 70 ECUs that use CAN FD to exchange information over the CAN bus when the engine is running or when the vehicle is moving. On a CAN bus, a frame is the basic unit of messaging. For a classic CAN bus, a frame consists of an 11-bit identifier along with an 8-byte message payload.
The C-300 was a racecar aimed at the NASCAR circuits that was sold for private ownership to qualify for homologation purposes, with Chrysler's most powerful engine, the OHV 331 cu in (5.4 L) FirePower "Hemi" V8, due to the hemispheric shape of the cylinder head, fitted with dual four barrel carburetors, two overhead valves per cylinder with ...
The vehicle responds to the PID query on the CAN bus with message IDs that depend on which module responded. Typically the engine or main ECU responds at ID 7E8h. Other modules, like the hybrid controller or battery controller in a Prius, respond at 07E9h, 07EAh, 07EBh, etc. These are 8h higher than the physical address the module responds to.
The need for a cheap serial network arose as the technologies and the facilities implemented in the car grew, while the CAN bus was too expensive to implement for every component in the car. European car manufacturers started using different serial communication technologies, which led to compatibility problems.