Ads
related to: central heating header tank diagram
Search results
Results From The WOW.Com Content Network
Expansion tank in a central heating system. An expansion tank or expansion vessel is a small tank used to protect closed water heating systems and domestic hot water systems from excessive pressure. The tank is partially filled with air, whose compressibility cushions shock caused by water hammer [citation needed] and absorbs excess water ...
A condensing boiler Hot water central heating unit, using wood as fuel. A central heating system provides warmth to a number of spaces within a building from one main source of heat. A central heating system has a furnace that converts fuel or electricity to heat.
English: Active indirect water heater. 1: Municipal water feed 2: Fluid from water storage tank to external (passive) heat source; passive heat source can be the ground (soil or groundwater), sun or air; eg via heat pump, or thermodynamic solar panel 3: Fluid from heat pump, or thermodynamic solar panel to water storage tank 4: Pump, actuator, controller and other parts 5: Water heater 6 ...
The inside of a hydraulically operated two-stage tankless heater, heated by single phase electric power. The copper tank contains heating elements with 7.2 kW maximum power. Tankless water heaters—also called instantaneous, continuous flow, inline, flash, on-demand, or instant-on water heaters—are gaining in popularity.
Trycock: a type of valve that is often used to manually check a liquid level in a tank. Most commonly found on a water boiler. Flash tank: High-pressure blowdown enters this vessel where the steam can 'flash' safely and be used in a low-pressure system or be vented to atmosphere while the ambient pressure blowdown flows to drain.
Central heating systems: These systems produce heat in one central location and distribute it throughout the building. This category includes furnaces, boilers, and heat pumps. [1] [2] Distributed heating systems: These systems generate heat in the space they are to heat, without extensive duct systems. Examples include electric space heaters ...
Air convection heating systems have been in use for over a century. Older systems rely on a passive air circulation system where the greater density of cooler air causes it to sink into the furnace area below, through air return registers in the floor, and the lesser density of warmed air causes it to rise in the ductwork; the two forces acting ...
The back boiler is typically used with a gravity feed circuit to the hot water cylinder, with a vent or overflow to prevent excess pressure build up.It can also be connected to a series of radiators to provide central heating but usually requires an electrical pump to be fitted to circulate the hot water, some systems can use the gravity circuit to include radiators.