Ads
related to: tube axial fan vs vane motor heater valve for generator
Search results
Results From The WOW.Com Content Network
The stall zone for the single axial fan and axial fans operated in parallel are shown in the figure. [4] The Figure shows the Stall Prone Areas differently for One fan and Two fans in parallel. [4] The following can be inferred from the graph : For the Fans operated in parallel, the performance is less when compared to the individual fans.
The axial fan is often contained within a short section of cylindrical ductwork, to which inlet and outlet ducting can be connected. Axial fan types have fan wheels with diameters that usually range from less than a foot (0.3 meters) to over 30 feet (9.1 m), although axial cooling tower fan wheels may exceed 82 feet (25 m) in diameter.
This type of fan is used in a wide variety of applications, ranging from small cooling fans for electronics to the giant fans used in cooling towers. Axial flow fans are applied in air conditioning and industrial process applications. Standard axial flow fans have diameters of 300–400 mm or 1,800–2,000 mm and work under pressures up to 800 ...
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
In the axial compressor the air flows parallel to the axis of rotation. Axial compressors are made to be multi-staged. A stage consists of a row of rotating blades called the rotor, which are connected to the central shaft and a row of stationary or fixed blades called stator. In axial flow compressor, the air flows from stage to stage.
A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream, such as a combustion turbine or other waste gas stream. It produces steam that can be used in a process ( cogeneration ) or used to drive a steam turbine ( combined cycle ).
The map may be produced by driving the compressor with an electric motor with the flow resistance selected artificially using a variable area throttle valve. The compressor may also be mapped if it is part of a gas generator with a valve at the turbine exit. Campbell [10] shows a General Electric J79 compressor mapped in this way.
Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.