Search results
Results From The WOW.Com Content Network
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
Diesel engine runaway is an occurrence in diesel engines, in which the engine draws excessive fuel from an unintended source and overspeeds at higher RPMs, producing up to ten times the engine's rated output resulting in a catastrophic mechanical failure due to a lack of lubrication. [1]
Including the Bricklin on its list of "The 20 Dumbest Cars of All Time", Autoblog wrote, "Memo to the world: When an automobile executive starts a new car company and proposes to name the car after himself, run like a stag in the opposite direction, lock your check book and credit cards in a safe and ask your best friend to keep the combination ...
The reduced engine speeds allow more time for autoignition chemistry to complete thus promoting the possibility of pre-ignition and so called "mega-knock". Under these circumstances, there is still significant debate as to the sources of the pre-ignition event. [3] Pre-ignition and engine knock both sharply increase combustion chamber temperatures.
Engine cooling removes energy fast enough to keep temperatures low so the engine can survive. [2] Some high-efficiency engines run without explicit cooling and with only incidental heat loss, a design called adiabatic. Such engines can achieve high efficiency but compromise power output, duty cycle, engine weight, durability, and emissions.
These engines can either be full-time lean-burn, where the engine runs with a weak air–fuel mixture regardless of load and engine speed, or part-time lean-burn (also known as "lean mix" or "mixed lean"), where the engine runs lean only during low load and at high engine speeds, reverting to a stoichiometric air–fuel mixture in other cases.
Crankcase dilution occurs when the fuel oil from the engine gets into the lube oil of the engine. This can be caused by the walls being wetted due to the fuel condensing in the cylinder. If the engine is cold, or there is an excess amount of cooling around the cylinder, [ 1 ] the fuel oil will condense and have a higher chance to end up in the ...
For instance, if a driver takes their foot off the clutch too quickly while stationary then the car will stall; taking the foot off the clutch slowly will stop this from happening. Stalling also happens when the driver forgets to depress the clutch and/or change to neutral while coming to a stop. [ 3 ]