Search results
Results From The WOW.Com Content Network
The height can make a substantial difference to the measured diameter. [3]In the United States, DBH is typically measured at 4.5 ft (1.37 m) above ground.
The Tule tree has a diameter of 38 feet 1.4 inches (1,161.8 cm) as measured by tape wrap, but because of its irregularity a cross-sectional wood area expressed as a circle gave an effective diameter of only 30 feet 9 inches (937 cm). The base of the tree was mapped in three dimensions using a frame mapping technique.
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13]
Academy ratio 1.375:1. The Academy ratio of 1.375:1 (abbreviated as 1.37:1) is an aspect ratio of a frame of 35 mm film when used with 4-perf pulldown. [1] [2] It was standardized by the Academy of Motion Picture Arts and Sciences as the standard film aspect ratio in 1932, although similar-sized ratios were used as early as 1928.
Length of an average flea is 1–10 mm (usually <5 mm) [27] 2.54 mm One-tenth inch; distance between pins in DIP (dual-inline-package) electronic components 5.70 mm Diameter of the projectile in 5.56×45mm NATO ammunition 10 −2: 1 centimeter 20 mm Approximate width of an adult human finger: 54 mm × 86 mm
A good example of this a 4×6 print (6 inch wide by 4 inch tall landscape) perfectly matches the 3:2 aspect ratio of a DSLR/35 mm, since 6/2=3 and 4/2=2. For analog projection of photographic slides, projector and screen use a 1:1 aspect ratio, supporting horizontal and vertical orientation equally well.
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
Examining the density formula, we see that the mass of a beam depends directly on the density. Thus if a beam's cross-sectional dimensions are constrained and weight reduction is the primary goal, performance of the beam will depend on Young's modulus divided by density.