Ads
related to: which ram slots should i use for pc
Search results
Results From The WOW.Com Content Network
Also, each module has eight RAM chips, but the lower one has an unoccupied space for the ninth chip; this space is occupied in ECC DIMMs. Three SDRAM DIMM slots on a ABIT BP6 computer motherboard. A DIMM (Dual In-line Memory Module) is a popular type of memory module used in computers.
Technically SO-DIMMs but called SO-RIMMs due to their proprietary slot. Compression Attached Memory Module , a standard developed by Dell, which uses a land grid array instead of the more common edge connector. Stacked vis-à-vis non-stacked RAM modules. Stacked RAM modules contain two or more RAM chips stacked on top of each other.
Dual-channel memory slots, color-coded orange and yellow for this particular motherboard. Dual-channel-enabled memory controllers in a PC system architecture use two 64-bit data channels. Dual-channel should not be confused with double data rate (DDR), in which data exchange happens twice per DRAM clock. The two technologies are independent of ...
The memory cell is the fundamental building block of computer memory. The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 (high voltage level) and reset to store a logic 0 (low voltage level). Its value is maintained/stored until it is changed by the set/reset process.
The lower memory clock frequency may also enable power reductions in applications that do not require the highest available data rates. According to JEDEC [5] the maximum recommended voltage is 1.9 volts and should be considered the absolute maximum when memory stability is an issue (such as in servers or other mission critical devices). In ...
Compared to DDR2 memory, DDR3 memory uses less power. Some manufacturers further propose using "dual-gate" transistors to reduce leakage of current. [10]According to JEDEC, [11]: 111 1.575 volts should be considered the absolute maximum when memory stability is the foremost consideration, such as in servers or other mission-critical devices.
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
PC-800 RDRAM operated with a latency of 45 ns, more than that of other SDRAM varieties of the time. RDRAM memory chips also put out significantly more heat than SDRAM chips, necessitating heatspreaders on all RIMM devices. RDRAM includes additional circuitry (such as packet demultiplexers) on each chip, increasing manufacturing complexity ...