Ads
related to: cutting plastic motorcycle fenders
Search results
Results From The WOW.Com Content Network
Timber was and is used for this application also. UHMWPE is chosen as facing of fender systems for berthing structures because of the following characteristics: [30] Wear resistance: best among plastics, better than steel; Impact resistance: best among plastics, similar to steel; Low friction (wet and dry conditions): self-lubricating material
A motorcycle fairing is a shell placed over the frame of a motorcycle, especially racing motorcycles and sport bikes, to deflect wind and reduce air drag. The secondary functions are the protection of the rider from airborne hazards and wind-induced hypothermia and of the engine components in the case of an accident.
Fender is the American English term for the part of an automobile, motorcycle or other vehicle body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire.
The 1997 KTM Jackpiner 200 LE was a limited production run of the first 200 cc KTM enduro motorcycle. It was built to celebrate the 30th anniversary of the first Penton KTM motorcycle. It came with Penton blue plastics and John Penton's signature on a sticker attached to the front fender. [7]
Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured; this process is known as compression molding ...
To be considered a chopper a motorcycle frame must be cut and welded at some point. I.e. the name chopper. [1] The "sissy bar", a set of tubes that connect the rear fender with the frame, and which are often extended several feet high, is a signature feature on many choppers.