Search results
Results From The WOW.Com Content Network
Bus width may refer to: Bus § Dimensions, the width of the road vehicle; Bus width, in computer architecture, the amount of data that can be accessed or transmitted ...
An address bus is a bus that is used to specify a physical address. When a processor or DMA-enabled device needs to read or write to a memory location, it specifies that memory location on the address bus (the value to be read or written is sent on the data bus). The width of the address bus determines the amount of memory a system can address.
Memory bus (interface) width: Each DDR, DDR2, or DDR3 memory interface is 64 bits wide. Those 64 bits are sometimes referred to as a "line." Those 64 bits are sometimes referred to as a "line." Number of interfaces : Modern personal computers typically use two memory interfaces ( dual-channel mode) for an effective 128-bit bus width.
A module composed of Micron Technology MT47H128M16 chips with the organization 128 Mib × 16, meaning 128 Mi memory depth and 16-bit-wide data bus per chip; if the module has 8 of these chips on each side of the board, there would be a total of 16 chips × 16-bit-wide data = 256 total bits width of data. For a 64-bit-wide memory data interface ...
These modules usually combine multiple chips on one circuit board. SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface. Some other computer architectures use different modules with a different bus ...
A module of any particular size can therefore be assembled either from 32 small chips (36 for ECC memory), or 16(18) or 8(9) bigger ones. DDR memory bus width per channel is 64 bits (72 for ECC memory). Total module bit width is a product of bits per chip and number of chips. It also equals number of ranks (rows) multiplied by DDR memory bus width.
For premium support please call: 800-290-4726 more ways to reach us
The memory bus connects the northbridge and RAM, just as the front-side bus connects the CPU and northbridge. Often, these two buses must operate at the same frequency. Increasing the front-side bus to 450 MHz in most cases also means running the memory at 450 MHz. In newer systems, it is possible to see memory ratios of "4:5" and the like.