Ads
related to: scout ii engine swaps
Search results
Results From The WOW.Com Content Network
The 1973 Scout IIs had 14 vertical bars between the headlights, a split in the middle, seven bars on each side surrounded by chrome trim pieces, and an "International" badge at the bottom left corner. 1974–75 Scout II grilles added a vertical bar trim overlay to the 1973 design. 1975 grilles had chrome and black square trim rings around the ...
The SD33T is a turbocharged 3.2 L; 198.0 cu in (3,245 cc) straight-six diesel engine that was used in 1980 for the powerplant in 6,400 International Scout II's. All were equipped with a T-19 manual transmission. From July 1983 until 1987, SD33T engines were fitted to the Nissan Patrol MK (160 series - model 2). The SD33T produces 110 PS (81 kW ...
This may be a like-for-like replacement, or to install a non-factory specification engine. Typically, an engine swap is performed for performance, swapping-in a more powerful engine; however, an engine swap may also be performed for maintenance, where older engines may have a shortage of spare parts, and so a modern replacement may be more ...
Tim Walz is a gearhead who owns an International Harvester Scout II — a quirky retro SUV that has gained a sizable following in recent years. Tim Walz is a car guy — and works on his own 1979 ...
(Scout) (Scout Motors) Performance-wise, the two trucks can go from 0-60 mph in only 3.5 seconds, with the four-wheel drive system (most likely dual motor) outputting 1,000 lb. ft of torque.
The naming system also changed, with the "D" being dropped and with a "10" being added in the series number. Thus, the new trucks were labelled 1010 through 1510, depending on weight ratings. The engine range was the same as for the earlier pickups, although AMC's 258 six was added later in 1971.
The GM Ecotec engine, also known by its codename L850, is a family of all-aluminium inline-four engines, displacing between 1.2 and 2.5 litres.Confusingly, the Ecotec name was also applied to both the Buick V6 Engine when used in Holden Vehicles, as well as the final DOHC derivatives of the previous GM Family II engine; the architecture was substantially re-engineered for this new Ecotec ...
The first version of this engine family was a normally aspirated 2.2 L (134 cu in) unit. Developed under the leadership of Chief Engineer – Engine Design and Development Willem Weertman and head of performance tuning Charles "Pete" Hagenbuch, who had worked on most of Chrysler's V-8 engines and the Chrysler Slant-6 engine, [1] it was introduced in the 1981 Dodge Aries, Dodge Omni, Plymouth ...