Search results
Results From The WOW.Com Content Network
The internal resistance of an ideal current source is infinite. ... (they can be thought of as connected in series). The transistor, Q1, adjusts the output (collector ...
Many equivalent series resistance (ESR) meters, essentially AC milliohm-meters normally used to measure the ESR of capacitors, can be used to estimate battery internal resistance, particularly to check the state of discharge of a battery rather than obtain an accurate DC value. [2] Some chargers for rechargeable batteries indicate the ESR.
MOSFETs, unlike PN junction devices (such as LEDs) can be paralleled because resistance increases with temperature, although the quality of this load balance is largely dependent on the internal chemistry of each individual MOSFET in the circuit; The main disadvantages of these FETs over bipolar transistors in switching are the following:
Voltage generators are modelled as an ideal voltage source in series with a resistor. Current generators are modelled as an ideal current source in parallel with a resistor. The resistor is referred to as the internal resistance of the source. Real world equipment may not perfectly follow these models, especially at extremes of loading (both ...
The current replication ratio may be altered by scaling the transistors, or by the insertion of degeneration resistors in series with the emitters, as was the case with the LH0002. To ensure correct mirroring, T1 and T2 (as well as the opposite pair T3 and T4) must be placed on the die in close proximity or, in case of discrete devices, mounted ...
Internal resistance varies with the age of a battery, but for most commercial batteries the internal resistance is on the order of 1 ohm. When there is a current through a cell, the measured e.m.f. is lower than when there is no current delivered by the cell.
The bipolar junction transistor, the first type of transistor to be mass-produced, is a combination of two junction diodes and is formed of either a thin layer of p-type semiconductor sandwiched between two n-type semiconductors (an n–p–n transistor), or a thin layer of n-type semiconductor sandwiched between two p-type semiconductors (a p ...
In this type the resistance varies with the applied voltage or current. Negative resistance vs positive resistance: If the I–V curve has a positive slope (increasing to the right) throughout, it represents a positive resistance. An I–V curve that is nonmonotonic (having peaks and valleys) represents a device which has negative resistance.