When.com Web Search

  1. Ads

    related to: taco 007 ifc circulator pump motor replacement 1 hp 2

Search results

  1. Results From The WOW.Com Content Network
  2. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...

  3. Boiler feedwater pump - Wikipedia

    en.wikipedia.org/wiki/Boiler_feedwater_pump

    Feedwater pumps range in size up to many kilowatts and the electric motor is usually separated from the pump body by some form of mechanical coupling. Large industrial condensate pumps may also serve as the feedwater pump. In either case, to force the water into the boiler, the pump must generate sufficient pressure to overcome the steam ...

  4. High efficiency glandless circulating pump - Wikipedia

    en.wikipedia.org/wiki/High_efficiency_glandless...

    The primary design factors of a high efficiency glandless circulating pump include an electronically commutated synchronous motor, a permanent magnet rotor, and canned rotor technology. An electronically commutated synchronous motor is used to convert the energy current from a DC energy source into an AC current which is supplied to the drive ...

  5. Oil pump (internal combustion engine) - Wikipedia

    en.wikipedia.org/wiki/Oil_pump_(internal...

    The type of pump used varies. Gear pumps [1] [2] trochoid pumps [3] and vane pumps [a] are all commonly used. Plunger pumps have been used in the past, but these are now only used rarely, for small engines. To avoid the need for priming, the pump is always mounted low-down, either submerged or around the level of the oil in the sump. A short ...

  6. Circulator - Wikipedia

    en.wikipedia.org/wiki/Circulator

    ANSI and IEC standard schematic symbol for a circulator (with each waveguide or transmission line port drawn as a single line, rather than as a pair of conductors). In electrical engineering, a circulator is a passive, non-reciprocal three- or four-port device that only allows a microwave or radio-frequency (RF) signal to exit through the port directly after the one it entered.

  7. Solar-powered pump - Wikipedia

    en.wikipedia.org/wiki/Solar-powered_pump

    A windpump replaced by a solar-powered pump at a water hole in the Augrabies Falls National Park. [Notes 1] This solar water pump up to 3.7 kW is useful for farmers.Solar-powered pumps run on electricity generated by photovoltaic (PV) panels or the radiated thermal energy available from collected sunlight as opposed to grid electricity- or diesel-run water pumps. [1]