Search results
Results From The WOW.Com Content Network
When braking, the rider in motion is seeking to change the speed of the combined mass m of rider plus bike. This is a negative acceleration a in the line of travel. F=ma, the acceleration a causes an inertial forward force F on mass m. The braking a is from an initial speed u to a final speed v, over a length of time t.
Motorcycle braking systems have varied throughout time, as motorcycles evolved from bicycles with an engine attached, to the 220 mph (350 km/h) prototype motorcycles seen racing in MotoGP. Most systems work by converting kinetic energy into thermal energy (heat) by friction.
Motorcycle Stability Control (MSC) is a motorcycle electronic brake control system developed by Robert Bosch GmbH. It is a lean-sensitive variation of the traditional ABS system Anti-lock braking system. The MSC system uses accelerometers and/or gyroscopic sensors to evaluate how close to the limit of adhesion the motorcycle is cornering.
Trail braking is a driving and motorcycle riding technique where the brakes are used beyond the entrance to a turn (turn-in), and then gradually released (trailed off). Depending on a number of factors, the driver fully releases brake pressure at any point between turn-in and the apex of the turn.
A combined braking system (CBS), also called linked braking system (LBS), is a system for linking front and rear brakes on a motorcycle or scooter. [1] In this system, the rider's action of depressing one of the brake levers applies both front and rear brakes. The amount of each brake applied may be determined by a proportional control valve ...
The main purpose of a slipper clutch is to prevent over engine rev and rear wheel hop (or clatter) especially under hard braking in a vehicle (usually performance motorcycles). It does so by partially slipping until the engine's speed matches with the vehicle's speed upon sudden braking. [1] [2]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
On automobiles, disc brakes are often located within the wheel A drilled motorcycle brake disc. The development of disc-type brakes began in England in the 1890s. In 1902, the Lanchester Motor Company designed brakes that looked and operated similarly to a modern disc-brake system even though the disc was thin and a cable activated the brake pad. [4]