Search results
Results From The WOW.Com Content Network
The most commonly used material is an oxide of a composition of ca. In 4 Sn. The material is a n-type semiconductor with a large bandgap of around 4 eV. ITO is both transparent to visible light and relatively conductive. It has a low electrical resistivity of ~10 −4 Ω·cm, and a thin film can have an optical transmittance of greater than 80% ...
Tape casting (also called doctor blading, knife coating, and shank shifting) [1] is a casting process used in the manufacture of thin ceramic tapes and sheets from ceramic slurry. [2] The ceramic slurry is cast in a thin layer onto a flat surface and then dried and sintered. [3] It's a part of powder metallurgy. [4]: 167
This surface could be used to produce new film or layers of material such as deposited coatings. It could be the base to which paint, adhesives, or adhesive tape is bonded. A typical substrate might be rigid such as metal, concrete, or glass, onto which a coating might be deposited.
A conversion coating is a chemical or electro-chemical treatment applied to manufactured parts that superficially converts the material into a thin adhering coating of an insoluble compound. These coatings are commonly applied to protect the part against corrosion , to improve the adherence of other coatings, for lubrication , or for aesthetic ...
Dennison Mending Tape from the second half of the 20th century. From the Museo del Objeto del Objeto collection. Pressure-sensitive tape, PSA tape, self-stick tape or sticky tape consists of a pressure sensitive adhesive coated onto a backing material such as paper, plastic film, cloth, or metal foil. It is sticky (tacky) without any heat or ...
An X-cut is made through the film with a carbide tip tool to the substrate. Pressure-sensitive tape is applied over the cut. Tape is smoothed into place using a pencil eraser over the area of the incisions. Tape is removed by pulling it off rapidly back over itself as close to an angle of 180°. Adhesion is assessed on a 0 to 5 scale.
The processed surface is then coated with electroless copper or nickel before further plating. This process gives useful (about 1 to 6 kgf/cm or 10 to 60 N/cm or 5 to 35 lbf/in) adhesion force, but is much weaker than actual metal-to-metal adhesion strength. Vacuum metallizing involves heating the coating metal to its boiling point in a vacuum ...
A typical PSA tape consists of a pressure-sensitive adhesive (the sticky part of the tape) coated to a backing material. To prevent the adhesive from sticking to the backing when wound in a roll, a release agent is applied to the backing or a release liner is placed on the adhesive. Sometimes a primer is coated between the adhesive and backing ...