When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [21]: 149 [18]: 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental penetration by a misplaced nail or screw. [21]: 149 Although the fittings are not cheap, they are reasonably durable (the rubber is typically neoprene or flexible PVC).

3. Sink - Wikipedia

   en.wikipedia.org/wiki/Sink

   A bottom mount sink at the Ernest Hemingway House. Bottom-mount or under-mount sinks are installed below the countertop surface. The edge of the countertop material is exposed at the hole created for the sink (and so must be a carefully finished edge rather than a rough cut). The sink is then clamped to the bottom of the material from below.

4. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Plastic hot and cold supply piping for a sink Plastic pipe is in wide use for domestic water supply and drain-waste-vent (DWV) pipe. Principal types include: Polyvinyl chloride (PVC) was produced experimentally in the 19th century but did not become practical to manufacture until 1926, when Waldo Semon of BF Goodrich Co. developed a method to ...

5. News, Politics, Sports, Mail & Latest Headlines - AOL.com

   firefox-startpage.aol.com

   Discover the latest breaking news in the U.S. and around the world — politics, weather, entertainment, lifestyle, finance, sports and much more.

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Heat sink - Wikipedia

   en.wikipedia.org/wiki/Heat_sink

   A pin fin heat sink with a Z-clip retainer Wire form Z-clips. More expensive than tape and epoxy, wire form z-clips attach heat sinks mechanically. To use the z-clips, the printed circuit board must have anchors. Anchors can be either soldered onto the board, or pushed through. Either type requires holes to be designed into the board.