Search results
Results From The WOW.Com Content Network
The three-dimensional orientation of a line can be described with just a plunge and trend. The rake is a useful description of a line because often (in geology) features (lines) follow along a planar surface. In these cases the rake can be used to describe the line's orientation in three dimensions relative to that planar surface.
For example, a dip of 45 degrees towards 115 degrees azimuth, recorded as 45/115. Note that this is the same as above. The term hade is occasionally used and is the deviation of a plane from vertical i.e. (90°-dip). Fold axis plunge is measured in dip and dip direction (strictly, plunge and azimuth of plunge).
A horizontal line would have a plunge of 0°, and a vertical line would have a plunge of 90°. [3] [7] A linear feature which lies within a plane can also be measured by its rake (or pitch). Unlike plunge, which is the feature's azimuth, the rake is the angle measured within the plane from the strike line. [3]
The new edition that was published in 2009, contains a 1:75,000 geology map of the island, 6 maps (1:25,000) containing topography, street directory and geology, a sheet of cross section and a locality map. The difference found between the 1976 Geology of Singapore report include numerous formations found in literature between 1976 and 2009.
Lineations in structural geology are linear structural features within rocks. [1] There are several types of lineations, intersection lineations, crenulation lineations, mineral lineations and stretching lineations being the most common. Lineation field measurements are recorded as map lines with a plunge angle and azimuth.
QAPF diagrams are not used if mafic minerals make up more than 90% of the rock composition (for example: peridotites and pyroxenites). Instead, an alternate triangle plot diagram is used; (see Streckeisen diagram, lower right.) An exact name can be given only if the mineralogical composition is established, which cannot be determined in the field.
[[Category:Geology templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Geology templates]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
Figure 1 is an example of a complex petrogenetic grid for metamorphosed pelitic rocks. It shows most of the important reactions that govern the development of aluminous mineral assemblages from the prehnite-pumpellyite facies to the granulite facies , as well as the blueschist facies and eclogite facies at higher pressures and the contact ...