Ads
related to: how to reset smoke alarm
Search results
Results From The WOW.Com Content Network
This will fully reset the smoke alarm and drain any charge left inside. Insert the new battery and close the battery compartment. Clean the unit with a microfiber cloth or a can of compressed air.
In its simplest form, the user activates the alarm by pulling the handle down, which completes a circuit and locks the handle in the activated position, sending an alarm to the fire alarm control panel. After operation, most fire alarm pull stations must be restored to the ready position using a special tool or key for the panel to be reset.
If an initiating device is still in alarm after the system is reset, such as a smoke detector continuing to sense smoke or a manual pull station still in an activated position, another alarm will be initiated, or in some cases the panel will refuse to reset until all the alarms have been reset/cleared. A system reset is often required to clear ...
When the sensors start to wear out, your detector becomes less reliable and in order to keep you and your home safe, you want to have a fully functioning smoke detector at all times.
Smoke dampers can be activated by the fire alarm system, usually initiated by smoke detectors, or interlocked with a fire suppression system. Smoke dampers close by an electric or pneumatic actuator, or a spring actuator, and can be either manually reset or driven open on a reset signal to the electric or pneumatic actuator.
Smoke detector mounted on a ceiling. A smoke detector is a device that senses smoke, typically as an indicator of fire.Smoke detectors/alarms are usually housed in plastic enclosures, typically shaped like a disk about 125 millimetres (5 in) in diameter and 25 millimetres (1 in) thick, but shape and size vary.
Fire alarm systems are required in most commercial buildings. They may include smoke detectors, heat detectors, and manual fire alarm activation devices (pull stations). All components of a fire alarm system are connected to a fire alarm control panel. Fire alarm control panels are usually found in an electrical or panel room.
On September 4, 1992, BRK recalled all hardwired smoke alarms under the series 1839I and 2839I due to testing programs determining that corrosion could form on the alarm horn's electrical contacts, causing the piezo to fail to make any noise. [6] In May 2006, First Alert combination smoke alarms were recalled due to draining batteries rapidly. [7]
Ad
related to: how to reset smoke alarm