Ads
related to: tandem axle trailer fenders for salethomasnet.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A "T" following the letters indicates a tandem rear axle. On LCFs equipped with inline-six diesels the engine intruded into the cabin. This was covered with a removable panel for maintenance. [2] A near unlimited range of engines, transmissions, and rear axles were available for what was usually a built-to-order truck.
Air over hydraulic and full air brakes were available. A driven front axle and tandem rear axles were available on some models (cab-over-engine models could have neither). Loaded weights were from 18,200 to 30,200 pounds (8,300 to 13,700 kg) and up to 50,000 pounds (23,000 kg) including trailers. [4]
The DM was an extra-heavy-duty version of the U often used in 6×4 construction trucks. Like the RMM, the DMM was all-wheel-drive, but it had not only a short hood and offset cab but also a set-back front axle, requiring a model-specific fiberglass hood-and-fender arrangement. [5] [6]
These were tandem-axle 6x4 drivetrain trucks for hauling heavier loads than their 4x2 counterparts. For example, the GVW of a L-194 is 25,500 vs the 38,000 of the LF-194. For example, the GVW of a L-194 is 25,500 vs the 38,000 of the LF-194.
Both models offered in set-back or set-forward front axle configuration 389: 2006–2024 on-highway (Class 8) Replaced 379, with redesigned headlamps, fenders, and trim. 131-inch BBC (longest-produced by Peterbilt). Offered in Australia (through 3rd-party conversion to right-hand drive) 389X 2006−2024 on-highway (Class 8)
The PayStar was a severe service conventional introduced in 1972. It used the same cab as the TranStar 4200/4300 and had a long, rectangular hood. It had a set-back front axle with a butterfly hood and flat diamond plate fenders. In 1973 a set-forward front axle model with a tilting fiberglass hood was added.