Search results
Results From The WOW.Com Content Network
A multicast address is a logical identifier for a group of hosts in a computer network that are available to process datagrams or frames intended to be multicast for a designated network service. Multicast addressing can be used in the link layer (layer 2 in the OSI model ), such as Ethernet multicast, and at the internet layer (layer 3 for OSI ...
In this implementation, each router within the network participates in the virtual routing environment in a peer-based fashion. While simple to deploy and appropriate for small to medium enterprises and shared data centers, VRF Lite does not scale to the size required by global enterprises or large carriers, as there is the need to implement ...
In cases where secondary/standby routers all have the same priority, the secondary/standby router with the highest IP address becomes the primary/active router. All physical routers acting as a virtual router must be in the same local area network (LAN) segment. Communication within the virtual router takes place periodically.
Multihoming is the practice of connecting a host or a computer network to more than one network. This can be done in order to increase reliability or performance. A typical host or end-user network is connected to just one network. Connecting to multiple networks can increase reliability because if one connection fails, packets can still be routed through the remaining connection. Connecting ...
Two routers must first be neighbors and only then, can they become adjacent. Two routers become adjacent if at least one of them is designated router or backup designated router (on multiaccess-type networks), or they are interconnected by a point-to-point or point-to-multipoint network type.
On a network with a single edge router, it is possible to implement source-specific routing by manual manipulation of routing tables. [6] With multiple routers, explicit support for source-specific routing is required in the routing protocol. As of early 2016, there are two routing protocols that implement support for source-specific routing:
The subnet router anycast address is the lowest address in the subnet, so it looks like the “network address”. If a router has multiple subnets on the same link, then it has multiple subnet router anycast addresses on that link. [19] The first and last address in any network or subnet is not allowed to be assigned to any individual host.
In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. [1] The IP forwarding algorithm states: [2] Given a destination IP address, D, and network prefix, N: