Ads
related to: cantilever scope mount vs rings m1a
Search results
Results From The WOW.Com Content Network
For a ring assembly to grip evenly, it is important that the scope rings are circular and coaxial with the scope tube. On ring mounts that grip unevenly, the ring mount can be lapped to prevent uneven pressure when mounting. [15] One scopes made for ring mounts, it is not uncommon to get ring marks when mounting the rings.
The M110's use of KAC's one-piece 30 mm scope mount instead of two separate scope rings. On June 12, 2008, the M110 was ranked #2 on the U.S. Army's top ten inventions of 2007. [ 5 ] According to performance specification (MIL-PRF-32316 (AR) w/AMENDMENT 1, 5 October 2009):
Smith Enterprise builds 30 mm scope rings and scope mounts primarily for use on AR-15, M16, M1A and M14 rifles. In 2005, Smith was the only company in the United States to produce scope rings and mounts via wire-cut electrical discharge machining (EDM). [20]
Another form of scope canting is caused by the rings themselves. Many Weaver-type mounts, including many Picatinny-type scope rings and even the Redfield Type, have either two or four screws on top of the scope ring that hold the scope in place. Both the Weaver and Picatinny clamp systems have a screw side and a clamp side. With the two-screw ...
The Scout Squad is an M1A marketed toward law enforcement users. It has an 18-inch (46 cm) barrel, a forward-mounted optical sight base, and a proprietary muzzle stabilizer. It is advertised as being optimal for Aimpoint optics, although most mounts attached to the factory accessory rail will still require a cheekrest in order to get the proper ...
Casemate-mounted 5"/50 caliber gun on the USS North Dakota. A casemate is an armoured structure consisting of a static primary surface incorporating a limited-traverse gun mount: typically, this takes the form of either a gun mounted through a fixed armour plate (typically seen on tank destroyers and assault guns) or a mount consisting of a partial cylinder of armour "sandwiched" between ...
It is similar in concept to the earlier commercial Weaver rail mount used to mount telescopic sights, but is taller and has wider slots at regular intervals along the entire length. The MIL-STD-1913 locking slot width is 0.206 in (5.23 mm). The spacing of slot centres is 0.394 in (10.01 mm) and the slot depth is 0.118 in (3.00 mm). [8]
The SR-25 enhanced match rifle utilizes the newer URX II Picatinny-Weaver rail system, rather than the older Mk 11 free-floating RAS, on the top of the receiver to accept different scope mounts or a carrying handle with iron sights (front sight mounted on the rail located on the forward end of the non-modular handguard). [4]