Ads
related to: decode check engine lights instantly start a vehicle change
Search results
Results From The WOW.Com Content Network
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The light normally appears when the vehicle ignition is turned on, but the engine is not running, as it detects no oil pressure due to the oil pump not operating (the oil pump is powered off the crankshaft, so only operates when the engine is running). It normally turns off a few seconds after engine start as the oil pump starts working and ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
Even more advanced devices allow users to reset engine DTC codes, effectively turning off engine lights in the dashboard; however, resetting the codes does not address the underlying issues and can in worst-case scenarios even lead to engine breakage where the source issue is serious and left unattended for long periods.
An indicator lamp (or indicator light) is an illuminated device that is intended to visually convey a single status to the user of a piece of equipment. Indicator lamp may refer to: Check engine light, a tell-tale warning light in automobiles; Tell-tale (automotive), a more generic class of indicators
With the start-message, a service can be initiated. It can be defined to confirm the beginning of the execution or to notify when the service is completed. With the Stop message, a running service can be interrupted at any time. The third option is a message to query the results of the service. The start and stop message parameters can be ...
If the breath sample isn't provided, or the sample exceeds the ignition interlock's preset blood alcohol level, the device will log the event, warn the driver, and then start up an alarm in accordance to state regulations (e.g., lights flashing, horn honking) until the ignition is turned off, or a clean breath sample has been provided. A common ...
A daytime running lamp (DRL, also daytime running light) is an automotive lighting and bicycle lighting device on the front of a road going motor vehicle or bicycle. [1] It is automatically switched on when the vehicle's handbrake has been pulled down, when the vehicle is in gear , or when the engine is started, emitting white, yellow , or ...