Ads
related to: can you undercoat over gloss coating on concrete slab roof
Search results
Results From The WOW.Com Content Network
Concrete undersealing is a process by which hot asphalt is pumped underneath the concrete slab so it flows into patches that were hollow and eroded. After concrete undersealing, the concrete is more stable and can be overlaid with a thin layer of asphalt to repair cracks, saving the expense and time of replacing the entire surface.
A 35 °C (95 °F) heat reduction was observed on this modified bitumen roof with a white, reflective roof coating. Roof coatings are seamless and when installed correctly, can solve roof leaks on almost any type of roofing material. There are exceptions: "professionals do not recommend using cool coatings over existing shingles.
The coating is applied between 1.25-1.5 lb per square yard and continues until the whole surface is covered. If the surface requires another coat, it must be applied within forty eight hours of the initial application of the hydrophobic mixture. Once applied, the concrete must cure in a moist environment two to three hours after the application.
A water-based primer, used primarily on wood. A primer (/ ˈ p r aɪ m ər /) or undercoat is a preparatory coating put on materials before painting.Priming ensures better adhesion of paint to the surface, increases paint durability, and provides additional protection for the material being painted.
Gypsum concrete is lightweight and fire-resistant. A 1.5-inch slab of gypsum concrete weighs 13 pounds per square foot versus 18 pounds per square foot for regular concrete. [10] Even though gypsum concrete weighs less, it still has the same compressive strength as regular concrete, based on its application as underlayment or top coat flooring ...
When a paint coating is applied on a metallic surface contaminated with soluble salts, an osmotic blistering process takes place (Figure 8.10). Osmosis is the spontaneous net movement of solvent molecules (water) through a semipermeable membrane (coating film) into a region of higher solute concentration (the salt contaminated substrate).