Ads
related to: berkeley jet drive impellers
Search results
Results From The WOW.Com Content Network
A jetboat is a boat propelled by a jet of water ejected from the back of the craft. Unlike a powerboat or motorboat that uses an external propeller in the water below or behind the boat, a jetboat draws the water from under the boat through an intake and into a pump-jet inside the boat, before expelling it through a nozzle at the stern.
Diagram of a typical gas turbine jet engine. Air is compressed by the compressor blades as it enters the engine, and it is mixed and burned with fuel in the combustion section. The hot exhaust gases provide forward thrust and turn the turbines which drive the compressor blades. 1. Intake 2. Low pressure compression 3. High pressure compression ...
A pump-jet, hydrojet, water jet, or jet drive uses a ducted propeller (axial-flow pump), centrifugal pump, or mixed flow pump to create a jet of water for propulsion. These incorporate an intake for source water and a nozzle to direct its flow out, generating momentum, and in most cases, employing thrust vectoring to steer the craft.
A pump-jet, hydrojet, or water jet is a marine system that produces a jet of water for propulsion. The mechanical arrangement may be a ducted propeller ( axial-flow pump ), a centrifugal pump , or a mixed flow pump which is a combination of both centrifugal and axial designs.
Several different types of pump impellers Flexible impeller of cooling system pump of an outboard engine (1 euro cent coin for comparison, diameter 16.25 mm). An impeller is a rotating component of a centrifugal pump that accelerates fluid outward from the center of rotation, thus transferring energy from the motor that drives the pump to the fluid being pumped.
The Heinkel HeS 011 or Heinkel-Hirth 109-011 (HeS - Heinkel Strahltriebwerke) was an advanced World War II jet engine built by Heinkel-Hirth.It featured a unique compressor arrangement, starting with a low-compression impeller in the intake, followed by a "diagonal" stage similar to a centrifugal compressor, and then a three-stage axial compressor.
Diagram of a typical gas turbine jet engine Frank Whittle Hans von Ohain. The turbojet is an airbreathing jet engine which is typically used in aircraft. It consists of a gas turbine with a propelling nozzle. The gas turbine has an air inlet which includes inlet guide vanes, a compressor, a combustion chamber, and a turbine (that drives the ...
Rolls Royce Goblin II numbered cutaway; the impeller of the centrifugal compressor is number 12. The very first jet engines used centrifugal compressors and they are still used on small turbojets and turbo shaft engines. The key component that makes a compressor centrifugal is the centrifugal impeller which contains a rotating set of blades.