Search results
Results From The WOW.Com Content Network
The solid solubility of the catalyzing agent is low in the solid and liquid phases of the substrate material. The equilibrium vapor pressure of the catalyst over the liquid alloy must be small so that the droplet does not vaporize, shrink in volume (and therefore radius), and decrease the radius of the growing wire until, ultimately, growth is ...
A supercritical fluid (SCF) is a substance at a temperature and pressure above its critical point, where distinct liquid and gas phases do not exist, but below the pressure required to compress it into a solid. [1] It can effuse through porous solids like a gas, overcoming the mass transfer limitations that slow liquid transport through such ...
Steam is water vapour (water in the gas phase), often mixed with air and/or an aerosol of liquid water droplets. This may occur due to evaporation or due to boiling, where heat is applied until water reaches the enthalpy of vaporization.
The difference is that in adsorption refrigeration, the refrigerant or adsorbate vapour molecules adsorb onto the surface of a solid instead of dissolving into a liquid. In an adsorption system, an adsorber adsorbs the refrigerant vapour into a solid, while in an absorption system, an absorber absorbs the refrigerant vapour into a liquid. [1]
The ethylene glycol either gains energy from the source (lake, ocean, water well) or dissipates heat to the sink, depending on whether the system is being used for heating or cooling. Pure ethylene glycol has a specific heat capacity about one half that of water. So, while providing freeze protection and an increased boiling point, ethylene ...
When the air becomes cold enough, water vapour in the air surrounding the leaf loses enough thermal energy to change into a solid. Even though the air temperature may be below the dew point, the water vapour may not be able to condense spontaneously if there is no way to remove the latent heat. When the leaf is introduced, the supercooled water ...
In physics and engineering, permeation (also called imbuing) is the penetration of a permeate (a fluid such as a liquid, gas, or vapor) through a solid.It is directly related to the concentration gradient of the permeate, a material's intrinsic permeability, and the materials' mass diffusivity. [1]
A small piece of rapidly melting solid argon shows two concurrent phase changes. The transition from solid to liquid, and gas to liquid (shown by the white condensed water vapour). Other phase changes include: Transition to a mesophase between solid and liquid, such as one of the "liquid crystal" phases.