Ads
related to: open door alarm circuit board instructions printable
Search results
Results From The WOW.Com Content Network
Dual-loop is a method of electrical circuit termination used in electronic security applications, particularly modern intruder alarms. It is called 'dual-loop' because two circuits (alarm and anti-tamper) are combined into one using resistors. Its use became widespread in the early 21st century, replacing the basic closed-circuit system, mainly ...
A simple electromagnetic door holder consists of a strong electromagnet, usually attached to a wall or mounted in a floor pedestal enclosure, next to the door it controls. The mechanism may be mounted near the floor, at the upper corner of the open door, or at any convenient height along the latch edge (away from the hinged edge).
In its simplest form, the user activates the alarm by pulling the handle down, which completes a circuit and locks the handle in the activated position, sending an alarm to the fire alarm control panel. After operation, most fire alarm pull stations must be restored to the ready position using a special tool or key for the panel to be reset.
Alarm control panel (ACP), or simply panel: The panel reads sensor inputs, tracks arm/disarm status, and signals intrusions. In a modern device, there are typically one or more computer circuit boards inside a metal enclosure. Many newer networks often use sealed plastic boxes.
A fire alarm notification appliance is an active fire protection component of a fire alarm system. A notification appliance may use audible, visible, or other stimuli to alert the occupants of a fire or other emergency condition requiring action. Audible appliances have been in use longer than any other method of notification.
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
Coded panels were the earliest type of central fire alarm control, and were made during the 1800s to the 1970s. A coded panel is similar in many ways to a modern conventional panel (described below), except each zone was connected to its own code wheel, which, depending on the way the panel was set up, would either do sets of four rounds of code until the initiating pull station was reset ...
This circuit shows a push button that closes a door and an obstruction detector that senses if something is in the way of the closing door. When the normally open push button contact closes and the normally closed obstruction detector is closed (no obstruction detected), electricity is able to flow to the motor which closes the door.