Ads
related to: end fed random wire sloping antenna height chart for women
Search results
Results From The WOW.Com Content Network
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [14] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.
The outer end of each radial wire, sloping down from the top of the antenna, is connected by an insulator to a supporting rope or cable anchored to the ground; the radial wires can also support the mast as guy wires. The radial wires make the antenna look like the wire frame of a giant umbrella (without the cloth) hence the name.
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
An inverted vee antenna is a type of antenna similar to a horizontal dipole, but with the two sides bent down towards the ground, typically creating a 120- or 90-degree angle between the dipole legs. It is typically used in areas of limited space as it can significantly reduce the ground foot print of the antenna without significantly impacting ...
A "shunt-fed" (or "slant-wire") antenna comprises a grounded tower with the top of a sloping single-wire feed-line attached at a point on the mast that results in an approximate match to the impedance desired at the other end of the sloping feed-wire. [1] [b] [c]
A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per section – converging but not touching at an angle of about 42° at the fed end and at the far end.