Ad
related to: chevy interference engine list
Search results
Results From The WOW.Com Content Network
1977–2013 Chevrolet 90° V6 engine (derived from the Chevrolet Small-Block" V8; now marketed as GM Vortec V6 or Vortec 4300 or EcoTec3 V6) 1979–2010 Chevrolet 60-Degree V6; 1994–2005 Opel 54-Degree L81 V6 (used in the Saturn Vue, Cadillac Catera and Saturn L series) 1995–present Suzuki H (used in several models built for GM by Suzuki)
A pair of poppet valves bent by collision with a piston after timing belt failure. The engine was running at 4500 RPM. In interference engine designs, replacing a timing belt in regular intervals (manufacturers recommend intervals ranging from 60,000 to 104,000 miles) or repairing chain issues as soon as they are discovered is essential, as incorrect timing may result in the pistons and valves ...
Atlas is a name for a family of modern inline piston engines for trucks from General Motors, used in the GMT355 and GMT360 platforms. The series debuted in 2002 with the Oldsmobile Bravada, and is also used in the Buick Rainier, the Chevrolet TrailBlazer and Colorado, the GMC Envoy and Canyon, the Hummer H3, Isuzu Ascender and i-370, and the Saab 9-7X.
This engine was similar to the LQ5, except that it used a two-barrel carburetor instead of a throttle-body fuel injection system. This engine was used in the Chevrolet S-10 and GMC S-15 compact pickup trucks and their Blazer and Jimmy counterparts until 1985, when it was replaced by the 2.5-liter Tech IV engine. This engine produced 83 hp (62 ...
From 1994 to 1997, it used sequential port fuel injection, and made 210 hp (157 kW) at 5200 rpm and 215 lb⋅ft (292 N⋅m) of torque at 4000 rpm. In 1996, the heads were redesigned for better flow, as well as now making the engine an interference design and adapting the engine for federally mandated OBD-II emissions. Output for the 1996–97 ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
Pages in category "Chevrolet engines" The following 26 pages are in this category, out of 26 total. This list may not reflect recent changes. 0–9.