Ad
related to: gm axle width chart
Search results
Results From The WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
The American-based international automotive conglomerate General Motors (GM) underpins its many vehicle models with various platforms.These platforms are established sets of axles, suspensions, and steering mechanisms which fit various bodies and powertrains from various marques that GM owns.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Front Axle. GM 1967-1976 K5(Blazer/Jimmy)/K10/K20 (Passenger side) Some 1977 K5 Blazers came with Dana 44s in the front, others came with a Corporate 10 bolt solid front axle. Dana 44s were also used as front axles in 4x4 converted full size Chevrolet and GMC vans by Pathfinder Equipment Company from 1973 to 1989. Dodge
The M1008 trucks used open Dana 60 front axles, with the M1028 and M1031 variations often having a Trac-Lok limited slip. In the rear, the M1008s used the GM 10.5-inch (270 mm) 10.5" Corporate 14 Bolt Differential with No-Spin lockers (the commercial trade name for the Detroit Locker). Rear axles on M1028A2 and A3 duallies are Dana 70 HD. The ...