Search results
Results From The WOW.Com Content Network
For example, factory and aftermarket receivers using the Remington 700 footprint are produced with various types of action threads, all with a 26.99 mm (1 + 1 ⁄ 16 in) diameter, but with a pitch of either a 1.588 mm (16 TPI, Remington standard), 1.411 mm (18 TPI) or 1.270 mm (20 TPI, Savage standard).
A Robertson screw, also known as a square screw [1] or Scrulox, [2] is a type of screw with a square-shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper .
Bar stock, also (colloquially) known as blank, slug or billet, [1] is a common form of raw purified metal, used by industry to manufacture metal parts and products. Bar stock is available in a variety of extrusion shapes and lengths. The most common shapes are round (circular cross-section), rectangular, square and hexagonal.
Model 14-1/2 Carbine The carbine version of the Model 14-1/2 had the same specs but with a shorter barrel of only 18.5 inches (47 cm). [4] Model 141 The Model 141, which was introduced as an upgrade to the Model 14, featured a white metal bead ramp front sight and a step-adjustable rear. [4]
Faced products on a shelf at a Coles supermarket. In the retail industry, facing (also known as blocking, zoning, levelling or dressing) is the practice of pulling products forward to the front of the display or shelf on which they are placed, typically with the items' labels facing forward. [1]
A machinist square or engineer's square is the metalworkers' equivalent of a try square. It consists of a steel blade inserted and either welded or pinned into a heavier body at an angle of 90°. Usually a small notch is present at the inside corner of the square.
Cutting-stock problems can be classified in several ways. [1] One way is the dimensionality of the cutting: the above example illustrates a one-dimensional (1D) problem; other industrial applications of 1D occur when cutting pipes, cables, and steel bars. Two-dimensional (2D) problems are encountered in furniture, clothing and glass production.
Using a try square to mark lines perpendicular to the edge. Using a try square to check if the full length of a board is square. The stock is usually held against the edge of the workpiece and either side of the tongue is then used as a straight edge for making a mark, or as a reference to check the accuracy of an angle. [7] [2]