Search results
Results From The WOW.Com Content Network
Jitter is the undesired deviation from true periodicity of an assumed periodic signal in electronics and telecommunications, often in relation to a reference clock source. Jitter may be observed in characteristics such as the frequency of successive pulses, the signal amplitude , or phase of periodic signals.
In the context of computer networks, packet jitter or packet delay variation (PDV) is the variation in latency as measured in the variability over time of the end-to-end delay across a network. A network with constant delay has no packet jitter. [11] Packet jitter is expressed as an average of the deviation from the network mean delay. [12]
Instantaneous packet delay variation is the difference between successive packets—here RFC 3393 does specify the selection criteria—and this is usually what is loosely termed "jitter", although jitter is also sometimes the term used for the variance of the packet delay. As an example, say packets are transmitted every 20 ms.
Bufferbloat is the undesirable latency that comes from a router or other network equipment buffering too many data packets.Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput.
Latency, from a general point of view, is a time delay between the cause and the effect of some physical change in the system being observed. Lag , as it is known in gaming circles , refers to the latency between the input to a simulation and the visual or auditory response, often occurring because of network delay in online games. [ 1 ]
The worst-case latency requirement is defined as 2 ms for Class A and 50 ms for Class B, but has been shown to be unreliable. [5] [6] The per-port peer delay provided by gPTP and the network bridge residence delay are added to calculate the accumulated delays and ensure the latency requirement is met. Control traffic has the third-highest ...
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
It specifies the latency for a bit of data to travel across the network from one communication endpoint to another. [1] [2]: 5 It is typically measured in multiples or fractions of a second. Delay may differ slightly, depending on the location of the specific pair of communicating endpoints.