Ads
related to: galvanized angle with holes in end of cord 1 female- Clearance Sale
Enjoy Wholesale Prices
Find Everything You Need
- Men's Clothing
Limited time offer
Hot selling items
- Store Locator
Team up, price down
Highly rated, low price
- All Clearance
Daily must-haves
Special for you
- Our Picks
Highly rated, low price
Team up, price down
- Today's hottest deals
Up To 90% Off For Everything
Countless Choices For Low Prices
- Clearance Sale
Search results
Results From The WOW.Com Content Network
The drill hole should be 1/2" longer than the depth penetration of the screw. The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1]
An angle bracket or angle brace or angle cleat is an L-shaped fastener used to join two parts generally at a 90-degree angle. It is typically made of metal but it can also be made of wood or plastic. Angle brackets feature holes in them for screws. A typical example use of is a shelf bracket for mounting a shelf on a wall.
Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.
The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:
A steel circular brush is attached to an angle grinder and used to remove the first layer leaving behind a bumpy surface similar to hammered bronze. In the glass industry for "fire polishing". In jewelry production for "water welding" using a water torch (an oxyhydrogen torch whose gas supply is generated immediately by electrolysis of water).
Calling that shield a shell (or D-shell) can be ambiguous, as the term shell is also short for the cable shell, or backshell. D-sub connectors have gender: parts with pin contacts are called male connectors or plugs, while those with socket contacts are called female connectors or sockets. The socket's shield fits tightly inside the plug's shield.