Ads
related to: 57 olds j2 engine rebuild near me prices
Search results
Results From The WOW.Com Content Network
The J-2 engine also had a slightly thinner head gasket, raising compression to 10.0:1. It was advertised with gross power and torque ratings of 312 hp (233 kW) at 4600 rpm and 415 lb⋅ft (563 N⋅m) at 2800 rpm. Oldsmobile charged $83 for the J-2 option with the three-speed manual (or in the 98), [7] $314 with the automatic. [8]
The standard J2 engine in Britain was the 3.6 L flathead V8 engine from the Ford Pilot, delivering 85 hp. [7] [8] A 4.4 L Mercury V8, delivering 110 hp was also available. [9] American enthusiasts modified their cars by fitting an Oldsmobile, Chrysler, or Cadillac V8. [4] [10] J2s exported to the United States were shipped without engines. [11]
The Oldsmobile Diesel engine is a series of V6 and V8 diesel engines produced by General Motors from 1978 to 1985. Their design was based on the Olds 350 gasoline engine architecture. A 350 cu in (5.7 L) V8 was introduced in 1978, followed by a 261 cu in (4.3 L) V8 only for the 1979 model year.
They used the expertise they had gained to start building production engines and cars which were renowned for their performance and luxury. Among the novel design features (for a pre-1940 production engine) seen on various Duesenberg engines are single- and double-overhead camshafts, three- and four-valve heads, superchargers and aluminum castings.
1948 Oldsmobile Straight-8 engine Oldsmobile inline 8 engine at the R. E. Olds Transportation Museum. Oldsmobile produced a straight-8 engine in the 1930s and 1940s. This was the company's top engine choice from 1932 until the 1949 introduction of the overhead valve Rocket V8, and was briefly exclusive to the Oldsmobile L-Series.
While similar in displacement to the other 4.3–4.4 L (265–267 cu in) V8 engines produced by General Motors (including the Oldsmobile 260 and Pontiac 265), the small bore 267 shared no parts with the other engines and was phased out after the 1982 model year due to inability to conform to emission standards. Chevrolet vehicles eventually ...
The GMC straight-6 engine was a series of gasoline-powered straight-six engines introduced in the 1939 model year by the GMC Trucks division of General Motors. Prior to the introduction of this new engine design GMC trucks had been powered by straight-six engines designed by the Buick , Pontiac and Oldsmobile divisions of GM.
The first Y-block on Ford automobiles and F100 trucks was the 239 cu in (3,910 cc) version as released in 1954 with EBU casting numbers. The Y-block was the same displacement as the old Ford Flathead V8 that it replaced but with a bigger bore and a shorter stroke (3.5 x 3.1 in).