Search results
Results From The WOW.Com Content Network
Bad SIP Protocol Extension used, not understood by the server. [1]: §21.4.15 421 Extension Required The server needs a specific extension not listed in the Supported header. [1]: §21.4.16 422 Session Interval Too Small The received request contains a Session-Expires header field with a duration below the minimum timer. [11]
This is a list of Simple Mail Transfer Protocol (SMTP) response status codes. Status codes are issued by a server in response to a client's request made to the server. Unless otherwise stated, all status codes described here is part of the current SMTP standard, RFC 5321. The message phrases shown are typical, but any human-readable alternative ...
Unlike the other status codes above, these were not sent as the response status in the HTTP protocol, but as part of the "Warning" HTTP header. [ 56 ] [ 57 ] Since this "Warning" header is often neither sent by servers nor acknowledged by clients, this header and its codes were obsoleted by the HTTP Working Group in 2022 with RFC 9111 .
The requested action is being initiated; expect another reply before proceeding with a new command. (The user-process sending another command before the completion reply would be in violation of protocol; but server-FTP processes should queue any commands that arrive while a preceding command is in progress.)
With the advent of the IEEE 802 suite of standards, a Subnetwork Access Protocol (SNAP) header combined with an IEEE 802.2 LLC header is used to transmit the EtherType of a payload for IEEE 802 networks other than Ethernet, as well as for non-IEEE networks that use the IEEE 802.2 LLC header, such as FDDI. However, for Ethernet, Ethernet II ...
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header. It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header. Both fields are eight bits wide.
Key Code Qualifier is an error-code returned by a SCSI device. When a SCSI target device returns a check condition in response to a command, the initiator usually then issues a SCSI Request Sense command. This process is part of a SCSI protocol called Contingent Allegiance Condition.
Error-free code words: aaaabbbbccccddddeeeeffffgggg Interleaved: abcdefgabcdefgabcdefgabcdefg Transmission with a burst error: abcdefgabcd____bcdefgabcdefg Received code words after deinterleaving: aa_abbbbccccdddde_eef_ffg_gg