Search results
Results From The WOW.Com Content Network
Conversions between units in the metric system are defined by their prefixes (for example, 1 kilogram = 1000 grams, 1 milligram = 0.001 grams) and are thus not listed in this article. Exceptions are made if the unit is commonly known by another name (for example, 1 micron = 10 −6 metre).
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples:
US spelling: cubic hectometer: 1.0 hm 3 (35,000,000 cu ft) cubic decametre: dam3 dam 3: US spelling: cubic dekameter: 1.0 dam 3 (35,000 cu ft) cubic metre: m3 m 3: US spelling: cubic meter one kilolitre 1.0 m 3 (35 cu ft) cubic decimetre: dm3 dm 3: US spelling: cubic decimeter one litre 1.0 dm 3 (61 cu in) cubic centimetre: cm3 cm 3: US ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
This regulation defines a standard cubic foot, for compressed or liquefied gases in refillable cylinders other than LPG by, "A standard cubic foot of gas is defined as a cubic foot at a temperature of 21 °C (70 °F) and a pressure of 101.325 kilopascals [kPa] (14.696 psia)".
Since an acre is defined as a chain by a furlong (i.e. 66 ft × 660 ft or 20.12 m × 201.17 m), an acre-foot is 43,560 cubic feet (1,233.5 m 3). There has been two definitions of the acre-foot (differing by about 0.0006%), using either the international foot (0.3048 m) or a U.S. survey foot (exactly 1200 / 3937 meters since
The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.
The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per minute (SCCM). In US customary units and imperial units, volumetric flow rate is often expressed as cubic feet per second (ft 3 /s) or gallons per minute (either US or imperial definitions).