Search results
Results From The WOW.Com Content Network
Adaptive feedback cancellation originated during the evolution of the hearing aid. The hearing aid became digital, and as such feedback cancellation was needed. In 1980 a directional microphone was introduced in the digital hearing aid, and adaptive feedback cancellation was created to block external noise that the microphone picked up. Today ...
Automixers balance multiple sound sources based on each source's level, quickly and dramatically adjusting the various signal levels automatically. [2] Automixers are used in live sound reinforcement to maintain a steady limit on the overall signal level of the microphones; if a public address system is set up so that one microphone will not feed back, then, in general, the automixer will ...
To maximize gain before feedback, the amount of sound energy that is fed back to the microphones must be reduced as much as is practical.As sound pressure falls off with 1/r with respect to the distance r in free space, or up to a distance known as reverberation distance in closed spaces (and the energy density with 1/r²), it is important to keep the microphones at a large enough distance ...
In both fields the amount of gain is measured in decibels at or just below the point at which the sound from the speaker driver re-enters the microphone and the system begins to ring or feed back. Potential acoustic gain (PAG) is a calculated figure representing gain that a system can support without feeding back. [1]
Here, the still-mic-level signal enters into a microphone preamplifier, which boosts the signal voltage to line level. For this example, the microphone preamplifier is built into a mixing board. It is typical for a mixing board to include a line trim after the preamplifier. This allows the amplitude of the now line-level signal to be adjusted.
Last year, the SEC announced charges against activist short seller Andrew Left and Citron Capital, in what regulators described "as a $20 million multi-year scheme to defraud followers by ...
“I think this mic stinks,” Trump said. “And then we don’t pay the contractor. I say don’t pay the contractor then they write a story, Trump doesn’t pay his bills, he’s a bad guy.”
This means that (1) moving the microphone closer to the sound source increases the signal level produced by the microphone, and (2) moving the microphone further away from undesirable noise sources will diminish the amount of noise in the microphone signal. Microphone placement is therefore an important aspect of gain staging [citation needed].